Description
Mosaic Pins for Knife Handle Custom Knives Blank Scales Grips Blades, Brass Copper Stainless Steel for EDC Folding Pocket Knives PinThis unique mosaic pin was hand-crafted by an expert. Add that extra bit of flair to your knife handle! This pin can be used for knife making, metal work, jewelry etc. It can be used as a solid pin or sliced into thin pieces for inlays. The pattern exists along the entire pin length use only the highest quality brass, copper and stainless steel pin requires a hole of 1cm to be drilled into the handle of your knife. You simply need to use drill bits intended for drilling metal, which are capable of drilling through the steel type of your bladeDo not expose to excessive heat when cutting the pins (it will become damaged over 95 degrees celsius). Do not polish them too much only sandpaper for polishing. Use 1200 grit sandpaper for final polishing last, use lacquer or oil mosaic pins have been vacuum-pumped to remove air bubbles. The resin is pulled in with a high-end vacuum, which pulls the glue down, and removes any small bubbles. The pins are cured afterward and lastly polished and burrs removed center of the mosaic pin is filled with clear epoxy resin. The filling will appear dark when initially received, however light will be able to shine through when you are done cutting this down to small pieces for your knife handle. The transparency will become evident with the smaller length pieces. As a note: It is possible to drill a knife blank’s pin holes larger (or create your own pin hole locations). You simply need to use drill bits intended for drilling metal, which are capable of drilling through hardened high carbon steel. This method is recommended because you be able will get the exact fit you are looking for when using our mosaic pins.