Description
Please note that only one pair of door handles is included suitable for one door. If you have two shower doors, please order two handles. Mounting hole is 5mm – Please cut 6mm or higher for slight clearance. This shower door replacement handle (as seen in photo) will fit a shower door which has fixing holes 145mm (14.5) apart. This is a robust, high quality handle which would be ideal for heavy glass doors, sliding and fixed. The handle is back to back, which means the the outer and inner handle are exactly the same. What’s includedT – As you can see in the photo which is one side of the handle which will be on the exterior of the shower door and the other side of the handle which will go on the interior of the handle. – Caps to cover the screw holes (which aren’t shown in the photo). How to install this shower door handle In terms of fitting something, this is one of the easiest DIY jobs you’ll probably face in the bathroom. Just follow the simple, step by step instructions outlined below and you’ll have the old handle taken off and the new one put on in less than 10 minutes. Step 1 – This is probably the trickiest part of the entire process and that’s removing the caps on the handle which is currently on your shower enclosure’s door. It’s simply a matter of prising the caps out, which is often easier said than done as they fit so tightly into the screw holes. To do this you’ll need a sharp object of your choosing (please be careful). Try to slip the sharp object in-between the handle and the cap and then try to pop the cap out. If the old handle is being thrown away you don’t have to worry about the aesthetics of the handle and can therefore be much less careful and forceful with this point. Again, please be very careful not to hurt yourself with the sharp object while applying pressure to it. Step 2 – Now that the caps are off, unscrew the screws at the top and the bottom of the handle with either a f