Description
Installation instructions: 1. Make sure your LED strip is 10mm wide SMD 5050 RGB LED strip with 4 copper contacts. 2. Open the connector. 3. Cut off your LED strip carefully along the cutting line. 4. Insert your LED strip into the connector, with the 4 copper contacts on your LED strip under the 4 electrical conductors in the connector. Make sure to match the + electrode on your LED strip to the + electrode on the connector. 5. Close the connector. Important note: If the connection is loose, the LEDs will flash or do not light up. To ensure a tight connection and good electrical conductivity, please refer to the following steps: After inserting the LED strip into the connector, before closing the connector, slightly pull and push the LED strip to adjust the connection point, until the LEDs light up. If the LEDs do not light up, please use a thin and hard object to simultaneously press hard on both ends of each electrical conductor in the connector, to make the positions of the 4 electrical conductors become lower. In this way, the 4 electrical conductors in the connector can totally touch the 4 copper contacts on the LED strip, and this will ensure good electrical conductivity. Package includes: 5x LED cable, 17cm long, with a connector and a female 4 pin interface at the ends 5x LED cable, 17cm long, with a connector at each end 10x 4-Pin LED quick connector 10x 4-Pin LED male to male plug