Description
6-Foot FT232RL FTDI USB to TTL serial adapter cable (6 wire end) for 3.3V logic level serial communication It is built with FTDI FT232 chip, FTDI’s royalty-free VCP allow for communication as a standard COM port and D2XX ‘direct’ drivers provide DLL application programming interface; a great conversion data cord to meet with your needs of debugging, boot-loading, programming, etc. NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FTDI official website The original FTDI chip is embedded in the USB-A end; 6 wire end is with VCC (5V power) and GND (ground), as well as RXD, TXD, RTS and CTS at 3.3V logic levelications: Upgrading Legacy Peripherals TTL serial port to USB Interface Microcontroller UART or I/O, FPGA / PLD to USB Replace MAX232 type level shifters allowing for direct connection of products to PC Industrial Control / USB Software / Hardware Encryption Dongles Features – The I/O pins of the FTDI wire are configured to operate at 3V3 logic level – Entire USB protocol handled by the electronics in the cable; – UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity; – Data transfer rates from 300 to 3M baud rate at TTL levels; – Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking; – Internal EEPROM with users writable area; – Supply voltage comes from USB bus, no external supply required; – UHCI / OHCI / EHCI host controller compatibleSpecific Interfaces: USB 2.0 type A Male Port ; 6 wire end Supports Windows 2008, XP and XP 64-bit, Vista and XP 64-bit, CE 4.2, 5.0 and 6.0; Windows 7, 8, 8.1, 10 (32 and 64-bit); Mac OS 8/9 , OS-X; Linux 2.4 and greater What’s Included 1 x USB to Serial TTL Converter Cord 1 X User Manual