Description
product description Packaging specifications: 30 x yellow connector; AWG: 12-10; 6.0mm diameter Shrink ratio is 2: 1 Shrinking temperature: 80 ℃ Temperature at which the welding ring begins to melt: 111˚C Welding ring temperature: 138˚C ● Note: This refers to the temperature of the connector surface, not the temperature that the hot air gun should set. Keep the hot air gun at a proper distance. Don’t get too close Steps for usage: 1: Select the correct size connector, screw the connector onto one wire, and twist the two conductors together. Make sure the ends of the stripped wires are clean and tidy (glossy). 2: Move the connector to the middle of the conductor. Make sure to strip the ends of the wires long enough so that they overlap each other and remain in the area of the solder sleeve. 3: Use a hot air gun or lighter to heat the cable sleeve until the solder ring melts and the adhesive reduces in size, filling the gap in the terminal until its wire melts. ● Tips: Some customers can use lighters to complete the joint. but we still strongly recommend using a hot air gun to heat shrink the connector, especially for beginners. ● No crimping required Suitable for hard-to-reach or space-constrained wiring solutions. Because these wire bond connectors do not require crimping, you can easily use them in hard-to-reach or limited space environments After sales service Our professional customer service team will be ready to solve your after-sales problems for you. Please feel free to buy. If there are any possible defective products, please contact us first. We will try our best to provide you with a replacement or refund.