Description
Important note: When you see the silver white wires inside, please do not think the wire is made of aluminum instead of pure copper. It is the pure copper wires that are electroplated with tin. Because pure copper is very easy to be oxidized and tin can prevent pure copper from being oxidized. If the pure copper is oxidized, the resistance will increase. Installation Instructions: 1re your LED light strip is 10mm wide and has 4 contacts (+, B, R and G). 2 the white clasp of the connector. 3 you use waterproof LED strip, you should peel off silicon on the surface around soldering/Cutting line area, then insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp; If you use non-waterproof LED strip, just insert the LED light strip into the clasp, with the 4 contacts of the led strip under the 4 prongs of the connector- make sure to match the + side of the strip to the + side of the clasp. 4e the clasp. Note: If the LEDs flicker or do not light up, it is because there is poor contact between the connector and the LED strip. To solve the problem, please follow these steps: 01r on your LED strip. 02 all the caps of the connector. 03rt your LED strip into the connector, slightly pull and push your LED strip to adjust the contact points between the 4 copper contacts on your LED strip and the 4 prongs in the connector. If the LEDs still do not light up, please use your finger to press a little hard on the 4 prongs in the connector. Package includes: 1x 20m/65.6ft Cable 10x clasp connectors for 10mm wide RGB 5050 LED strips