Description
This flaring tool kit is an ideal tool for pipe flaring, and it can be used to make single or double flares on copper, brass and thin walled aluminum tubes. High quality steel material ensures strong strength and long durability. All of these tools are packed in a carry case for easy storage and transportation.
Specifications:
Material: 45# Steel
Color: As Picture Shown
Flare Dies Size: 1/2inch, 6mm, 4.75mm, 5mm, 1/4inch, 8mm, 10mm
Clamp Size: 12.5 x 8.2cm/4.9” x 3.2”
Carry Case Size: 21 x 13.5 x 2.7cm/8.3” x 5.3” x 1”
Used On: Copper, brass or thin walled aluminum tube, etc
Package Weight: Approx. 1.022kg
Instruction:
1. Clean the tube end.
2. Insert the tube from bottom of the clamp until the edge get even on the top.
3. Slide the ratchet cone into the clamp and line the arrow to the mark.
4. Tighten the side T bar.
5. Turn the cone driving screw down until you hear the clutch click.
6. Loose the cone driving screw and side T bar. Remove from the clamp. And take the tube off.
Package Included:
1 x Clamp
1 x Spreader
7 x Double Flare Dies
1 x Storage Case