Description
This is a high quality 868.3Mhz clone remote that clones your ZAPF D302-868, D302-868, D313-868, D321-868, D323-868, COMMAND 131 remote controls. Parameters: Frequency: 868.3 MHz battery and key fob included. How to clone your remote control: you need to erase the remote control first: 1) Press and hold the LOCK and UNLOCK buttons together – LED flashes 3 times 2) Hold down the LOCK button and press the UNLOCK button 3 times, the LED will flash continuously. The clone remote is now clear and ready to clone. Next, you need to clone your original remote: 1) Place both remote controls in the rear position (II). Make sure they have direct contact and touch. 2) Press and hold 1 button on your original remote and 1 button on your clone remote. Hold the button until the LED lights up: 2 flashes > 3 times > Steady on = Successful cloning only when the light is on permanently. If the clone remote does not flash further than 2 times for any reason, it means that the signal does not come through. Please slowly slide the remote up and down until you reach the point where the signal comes through. SIDE BY SIDE PROGRAMMING VIDEO: s://.youtube/watch?v=JVcNcQ8abC8 Back-to-Back PROGRAMMING VIDEO: s://.youtube/watch?v=n0-QgtmCWJI Note: You don’t need access to your control board or receiver! If you need car sun visor clip holder for remote controls, you can buy it here: s://.store.de/dp/B07FVW7F59. If you want to increase the range of the remote control reception to 150-200 metres, you can connect this antenna: s://.store.de/dp/B01MZYAPVN/